Crown XLS 602 Benutzerhandbuch
XLS Series Power Amplifi ers
Operation Manual
page 6
Figure 3.4. Input Connector Wiring
3 Setup
3.5 Choose Input Wire
and
and
Connectors
Crown recommends using pre-built or profes-
sionally wired, balanced line (two-conductor
plus shield), 22-24 gauge cables and connec-
tors. You should use 3-pin male XLR cable
ends at the amplifi er inputs. Unbalanced line
may also be used but may result in noise over
long cable runs.
sionally wired, balanced line (two-conductor
plus shield), 22-24 gauge cables and connec-
tors. You should use 3-pin male XLR cable
ends at the amplifi er inputs. Unbalanced line
may also be used but may result in noise over
long cable runs.
Note: Male XLR signal links are also provided
on the amplifi er to allow daisy-chaining of the
audio signal.
on the amplifi er to allow daisy-chaining of the
audio signal.
Refer to Figure 3.4 for correct XLR connector
pin assignments.
pin assignments.
NOTE: Custom wiring should only be
performed by qualifi ed personnel.
performed by qualifi ed personnel.
Figure 3.5. Output Connector Wiring
3.6 Choose Output Wire
and
and
Connectors
Crown recommends using pre-built or pro-
fessionally wired, high-quality, two- or four-
conductor, heavy gauge speaker wire and
connectors. You may use banana plugs, spade
lugs or bare wire for your output connectors
(see Figure 3.5). To prevent the possibility
of short-circuits, wrap or otherwise insulate
exposed loudspeaker cable connectors.
fessionally wired, high-quality, two- or four-
conductor, heavy gauge speaker wire and
connectors. You may use banana plugs, spade
lugs or bare wire for your output connectors
(see Figure 3.5). To prevent the possibility
of short-circuits, wrap or otherwise insulate
exposed loudspeaker cable connectors.
Using the guidelines below, select the appro-
priate size of wire based on the distance from
amplifi er to speaker.
priate size of wire based on the distance from
amplifi er to speaker.
Distance Wire
Size
up to 25 ft.
16 gauge
26-40 ft.
14 gauge
41-60 ft.
12 gauge
61-100 ft.
10 gauge
101-150 ft.
8 gauge
151-250 ft.
6 gauge
CAUTION: Never use shielded cable for
output wiring.
output wiring.