Crown xls 202 Техническое Руководство

Seite von 2
Crown International
P.O. Box 1000
Elkhart, IN 46515-1000
TEL: 574-294-8200
FAX: 574-294-8FAX
www.crownaudio.com
4/03                                                            135738-3A  
 
Crown’s Three-Year, No-Fault, Fully Transferable Warranty
Crown offers a Three-Year, No-Fault, Fully Transferable Warranty for every new Crown ampli-
fi er—an unsurpassed industry standard. With this unprecedented No-Fault protection, your new 
Crown amplifi er is warranted to meet or exceed original specifi cations for the fi rst three years of 
ownership. During this time, if your amplifi er fails, or does not perform to original specifi cations, 
it will be repaired or replaced at our expense. About the only things not covered by this warranty 
are those losses normally covered by insurance and those caused by intentional abuse. And the 
coverage is transferable, should you sell your amplifi er.
See your authorized Crown dealer for full warranty disclosure and details. For customers outside 
of the USA, please contact your authorized Crown distributor for warranty information or call 
574-294-8200.
XLS SERIES
Specifi cations subject to change without prior notice. Latest 
information available at www.crownaudio.com.
Crown is a registered trademark of Crown International. 
Other trademarks are the property of their respective owners. 
Printed in U.S.A.
© 2003 Crown Audio, Inc.
Input/Output
Input Connectors: One per channel; back-
panel three-pin female XLR input connectors.
Input Impedance (nominally balanced, nomi-
nally unbalanced): 20 k ohms, 10 k ohms.
Output Connectors: One 4-pole Speakon
®
 
connector and one pair of back-panel, 5-way 
binding posts per channel; accepts banana 
plugs, spade lugs or bare wire. (European 
models do not accept banana plugs.)
DC Output Offset (shorted input): ±10 millivolts.
Output Signal: Stereo, unbalanced, two-channel.
Protection
XLS Series amplifi ers provide extensive pro-
tection and diagnostic capabilities, including 
output current limiting, DC protection, circuit 
breaker, and special thermal protection for 
the unit’s transformers.
Construction
Ventilation: Flow-through ventilation from 
front to back.
Cooling: Internal heat sinks with forced-air 
cooling for rapid, uniform heat dissipation. 
Air Volume Requirements (per minute per 
unit): 80.15 ft³ (2.27 m³).
Dimensions: EIA Standard 19-inch (48.3-cm) 
rack mount width (EIA RS-310-B), 3.5-inch 
(8.9-cm) height and 14-inch (35.6-cm) depth 
behind the mounting surface.
Weight 
Net Weight:
   XLS-202: 21.0 lbs. (9.5 kg).
   XLS-402: 25.3 lbs. (11.5 kg)
   XLS-602: 27.2 lbs. (12.3 kg)
Shipping Weight:
   
XLS-202: 26.0 lbs. (11.8 kg)
   XLS-402: 30.3 lbs. (13.8 kg)
   XLS-602: 32.2 lbs. (14.6 kg)