Crown 1160ma Benutzerhandbuch
Operation Manual
Xs Series Power Amplifiers
page 8
2.6 Wire Your System
2.6.1 Stereo Mode
Typical input and output wiring is shown in
Figures 2.8 and 2.9.
Figures 2.8 and 2.9.
INPUTS: Connect input wiring for both channels.
OUTPUTS: Connect speakers to the 5-way binding posts or to
the two Speakon
the two Speakon
®
connectors. See the details below.
Connection to 5-way binding posts:
1. Connect speaker 1 positive (+) lead to the amp’s Channel-1
positive (red) binding post.
positive (red) binding post.
2. Connect speaker 1 negative (–) lead to the amp’s Channel-1
negative (black) binding post.
negative (black) binding post.
3. Connect speaker 2 positive (+) lead to the amp’s Channel-2
positive (red) binding post.
positive (red) binding post.
4. Connect speaker 2 negative (–) lead to the amp’s Channel-2
negative (black) binding post.
negative (black) binding post.
Connection to Speakon
®
connectors:
1. Connect speaker 1 positive (+) lead to the amp’s Channel-1
Speakon
Speakon
®
terminal 1+.
2. Connect speaker 1 negative (–) lead to the amp’s Channel-1
Speakon
Speakon
®
terminal 1–.
3. Connect speaker 2 positive (+) lead to the amp’s Channel-2
Speakon
Speakon
®
terminal 1+.
4. Connect speaker 2 negative (–) lead to the amp’s Channel-2
Speakon
Speakon
®
terminal 1–.
2.6.2 How to Parallel the Inputs
There are three ways to feed the same signal to each amplifier
channel:
channel:
1. Buy a “Y” cable. Plug the female end into your signal cable, and
plug the split male ends into both amplifier inputs.
plug the split male ends into both amplifier inputs.
2. Feed your signal to the Channel-1 input (either Phoenix or
combo). Connect a jumper wire (Figure 2.9) between the Phoenix
Channel-1 (+) screw terminal and the Channel-2 (+) screw termi-
nal. Connect another jumper wire between the Channel-1 (–)
screw terminal and the Channel-2 (–) screw terminal.
combo). Connect a jumper wire (Figure 2.9) between the Phoenix
Channel-1 (+) screw terminal and the Channel-2 (+) screw termi-
nal. Connect another jumper wire between the Channel-1 (–)
screw terminal and the Channel-2 (–) screw terminal.
3. Feed your signal to the Channel-1 Phoenix terminals. Using a
mic cable or phone-to-phone cable, connect Channel-1 combo
jack to Channel-2 combo jack.
mic cable or phone-to-phone cable, connect Channel-1 combo
jack to Channel-2 combo jack.
2 Setup
CHANNEL 2
CHANNEL 1
Figure 2.8
Stereo Wiring
Figure 2.9
Phoenix Connector Wiring for
Parallel Inputs