Phase Technology ci-mm3 Installationsanweisungen

You have just purchased a revolutionary innovation from Phase 
Technology.  The Micro-Module is the first “fits-anywhere” high 
definition, custom installation speaker system ever developed.  Now 
you can fit this high definition speaker anywhere you would position an 
electrical outlet or wall switch.  The module is designed for distributed 
sound to be used in non-traditional applications where larger more 
conventional in-wall speakers will not fit.  Their application is only 
limited to your imagination and creativity.  The versatile Mico-Module is 
water resistant, making it ideal for close proximity placement near 
showers, tubs, pools, and spas.  Use the Micro Module as a near field 
monitor in offices, kitchens, bedrooms, and bathrooms any area where 
a controlled volume is preferred and where high definition music 
playback is desired. 
 

Each Micro Module is complete speaker system.  This box contains one 
Micro Module with 12 dB per octave crossover network, one white wall 
plate/grille assembly and one ivory wall plate/grille assembly and color-
matched screws for installation.  You will need a narrow blade (3/32”) 
standard screwdriver similar to a jewelers a screwdriver, wire strippers 
and a medium standard screw driver. 

 
Module Installation Procedure/with Subwoofer 

The Micro-Module is designed to fit into both new construction and 
retrofit type nylon dual gang electrical boxes or plaster rings (p-ring). 
These are the standard blue and gray plastic electrical boxes found in 
any hardware store or home center.  Each Micro-Module is designed to 
be used with a subwoofer or as a stand one full range speaker.  If you 
intend to use the Micro-Module with the passive subwoofer, you need 
only to connect your speaker wire to the terminal maintaining proper 
phase connection.  Insert the module into the electrical box and hold in 
place as you align the cover plate.  The holes of the cover plate are 
slotted to grip the mounting screws, insert the screws into the slots so 
that approximately ½” protrudes through the back of the plate.  Align 
the screws through the speaker mounting plate then insert the 
speaker/plate into the electrical box (p-ring) and secure the screws. 

 

Each Micro-Module may be used as a stand-alone full range driver.  If 
the Micro-Module is to be used without a subwoofer.  The crossover is 
designed to work with the matching subwoofer and the normal cutoff is 
300 Hz.  Follow the mounting instructions described above. 
 

 

The system consists of two Micro-Modules and a woofer with a  system 
impedance of 8 ohms. In larger rooms, we recommend additional 
Micro-Modules to distribute the sound throughout the room.  Wiring the 
additional Micro Modules in parallel will result in a 4 ohm impedance.  
Many modern speaker systems have nominal impedance of 4 ohms, 
most modern receivers and amplifiers will drive a 4 ohms load with no 
difficulty.  Contact your Phase Technology dealer for professional 
advice on system installation. 
 

 

For a typical system, use the diagram below.  Use care to maintain 
correct phase by connecting the positive (+) terminal & negative (-) 
terminal on the amplifier to the corresponding (+) & (-) terminals on the 
woofer and the Micro Modules.  When pre wiring new construction, new 
recommend 4 conductors of 16 gauge or heavier wire be run from the 
amplifier location to the woofer location.  At the time of final connection 
the signal would travel from the amplifier through the woofer crossover, 
then out to the Mico-Modules.  This will result in the least amount of 
wire at the back of the amplifier resulting in a clean connection. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

218-1105