Maytag MHW6000X Installationsanweisungen

Run water for a few seconds through hoses into a laundry  

tub, drainpipe, or bucket to prevent clogs. Water should run  

until clear.

For floor drain installations, you will need to remove the drain 

hose form from the end of the drain hose. You may need  

additional parts with separate directions. See “Alternative 

Parts”.

Place hose into standpipe (shown in picture) or over side of   

laundry tub.

IMPORTANT: Only 4.5" (113 mm) of drain hose should be 

inside standpipe; do not force excess hose into standpipe or 

lay on bottom of laundry tub. Drain hose form must be used.

Drain

hose form

Washer must be connected to water faucets with new inlet 

hoses with flat washers. Do not use old hoses.
NOTE: Both hoses must be attached and have water flowing 

to inlet valves. For optimal performance, hot and cold water 

must be supplied to the washer.

Attach hose to hot water faucet. Screw on coupling by hand 

until it is seated on washer. Use pliers to tighten couplings an 

additional two-thirds turn. Repeat this step with second hose 

for cold water faucet.

IMPORTANT: Do not overtighten or use tape or sealants on 

valve when attaching to faucets or washer. Damage can result.

HELPFUL TIP: Make note of which hose is connected to hot 

water to help in attaching hoses to washer correctly. In most 

standard configurations, hoses will cross over each other 

when attached correctly.