Philips 2g350a2h Betriebsanweisung
5
INSTALLATION
System requirements
Hardware: a PC which supports the USB function and has a USB
Hardware: a PC which supports the USB function and has a USB
outlet
Software: Windows system which suppor ts USB
(OSR2.1 or higher).
Installation of USB module
1. Turn off the monitor and unplug the power card
2. Remove the cover of “USB AY” at the back of the
2. Remove the cover of “USB AY” at the back of the
monitor.
3. Inser t USB module into the slot
4. Fix the USB module to the monitor by screwing
5. Do not tighten the fixing nut excessively (use fingers
4. Fix the USB module to the monitor by screwing
5. Do not tighten the fixing nut excessively (use fingers
to tighten screws) If screwed too right, the unit may
not connect properly!
not connect properly!
6. Plug-in the power cord and turn on the monitor.
To establish the USB connection
7. Inser t disk.
8. The two ends of USB cable attached are different.
8. The two ends of USB cable attached are different.
Plug-in the flat end into the “upstream” outlet of the
USB module .
USB module .
9. Plug-in the other end into the USB outlet of the PC .
10. Windows recognises two new pieces of hardware
-philips USB hub
-USB Human Interface Device
-USB Human Interface Device
This last item is presented through a wizard.
Follow the “next” steps on screen (choose the
“recommended” options) until installation has been
finished.
Follow the “next” steps on screen (choose the
“recommended” options) until installation has been
finished.
4
APPLICATION
R
=
1
4
7
2
5
3
6
8
9
#
0
*
SEKR
SEKR
R
=
1
4
7
2
5
3
6
8
9
#
0
*
SEKR
keyboard
mouse
joystick
scanner
printer
phone / PBX
USB HUB