Cleveland ogb-10.10 Zusätzliches Handbuch

 

 

 

•

  Do NOT interrupt the automatic cleaning process. Interrupting and restarting the 

Automatic Cleaning System with the ON/OFF key may start a 6 minute forced rinsing of 

the oven chamber to remove any CONVOClean and CONVOCare residue when the 

ON/OFF key is turned back ON. The Signal Tone sounds at the end of the forced rinsing 

cycle and the Combi is ON. 

•

  Do not open the Combi door during the automatic cleaning process, unless the 

instruction “Open the door” and “close the door,” appears in the display. 

•

  Pre-clean manually to save water and CONVOClean by selecting a lower cleaning 

setting. 

•

  If the security questions are not answered within 5 seconds, the Combi resets itself to the 

query level and will not start. 

•

  If the message “No cleaner pressure” appears, check that there is enough CONVOClean 

and/or CONVOCare in the correct containers. Refill them if necessary (red hose for 

CONVOClean, and blue or white hose for CONVOCare). 

A.  See P/N 260AZA, “Instructions for CONVOClean System Start-up Kit,” for hose attachment, 

solution mixing, and other information. 

B.  The CONVOClean Automatic Cleaning Process 

1.  The oven chamber must be cold before starting this process. If the oven chamber is still 

hot, the error message, “oven temp too hi / please wait” appears in the display. If this 

error message appears, open the Combi door, wait 15 minutes and then try to start the 

automatic cleaning process. Repeat as needed. 

2.  Before starting, remove large pieces food or cooking residue from the oven chamber to 

help prevent the drain from becoming blocked. 

3.  Check the level of Convotherm by Cleveland CONVOClean and CONVOCare. 

a. The containers must be full. 
b.  The suction pipes must be located in the fluid. 
c.  The hoses must be properly attached to the Combi. 

4.  Press the Smart Key. Various options appear in the display. 
5.  Use the Selector Dial to select “CONVOClean system” 

 . 

6.  Confirm by pressing the Smart Key. 
7.  PRESS the Temperature key and select the cleaning level (1-4) with the Selector Dial. 

Approximate run times are listed to help plan use of the CONVOClean system. Times 

may vary by +/- 15 minutes. 
1 “Light 

Soiling” 

  55 

minutes. 

2 

“Medium Soiling” 

 

1 hour and 30 minutes. 

23