Garmin 2610 Benutzeranleitung

68

Removing and Installing the CompactFlash® (CF) Storage Card
The StreetPilot 2610/2650 supports Type I and II CompactFlash® (CF) storage cards. The top of the card 
should always face towards the FRONT of the unit when inserting. Type I cards have a slight ridge on the 
bottom of the card that aids with removal. When removing Type II cards, avoid pinching the card in the 
middle; instead, grab the card by the top and bottom edges.

1.  Slide UP on the top portion of the CF card door, then open the door away from the unit.
2.  Insert the CompactFlash card into the slot with the top facing toward the front of the StreetPilot. Gently 

push the card in until the eject button extends out to about the end of the CF card. Do not apply 

unit! When properly inserted, the CF card protrudes slightly from the slot (not flush).

3.  Close the card door by pushing the top of the card door towards the unit until it clicks and locks. Always 

close the door completely to prevent water entry.

4.  To remove the card, repeat step one, then push the eject button until it is flush with the casing. Gently 

slide the CF card out of the unit. 

Opening 
the CF Card 
Door

1

2

Installing the CF Card

Eject Button

Removing the CF Card

CompactFlash® cards are widely available  and 

you can purchase additional cards at many different 

retailers. Because Garmin does not manufacture these 

cards, it is possible that CompactFlash cards by certain 

manufacturers may generate radio frequency signals 

that interfere with the operation of your StreetPilot. 

These circumstances are beyond Garmin’s control. 

If this occurs, please use a CF card from a different 
manufacturer. 

Top

Top

Type I CF Card

Type II CF Card

Ridge