Fortinet fortigate-200a Betriebsanweisung

This example shows how to set the OSPF router ID to 1.1.1.1:

config router ospf

set router-id 1.1.1.1

end

This example shows how to display the OSPF settings.

default-metric 
<metric_integer>

Specify the default metric that OSPF 

should use for redistributed routes. The 

valid range for metric_integer is 1 to 

16777214.

10

All models.

distance 
<distance_integer>

Configure the administrative distance for 

all OSPF routes. Using administrative 

distance you can specify the relative 

priorities of different routes to the same 

destination. A lower administrative 

distance indicates a more preferred route. 

The valid range for distance_integer 

is 1 to 255.

110

All models.

passive-interface 
<name_str>

OSPF routing information is not sent or 

received through the specified interface.

No 

default.

All models.

rfc1583-compatible 
{disable | enable}

Enable or disable RFC 1583 compatibility. 

RFC 1583 compatibility should be enabled 

only when there is another OSPF router in 

the network that only supports RFC 1583. 

When RFC 1583 compatibility is enabled, 

routers choose the path with the lowest 

cost. Otherwise, routers choose the lowest 

cost intra-area path through a non-

backbone area.

disable All models.

router-id 
<address_ipv4>

Set the router ID. The router ID is a unique 

number, in IP address dotted decimal 

format, that is used to identify an OSPF 

router to other OSPF routers. The router 

ID should not be changed while OSPF is 

running.
A router ID of 0.0.0.0 is not allowed.

No 

default.

All models.

spf-timers 
<delay_integer> 
<hold_integer>

Change the default shortest path first 

(SPF) calculation delay time and 

frequency. 
The delay_integer is the time, in 

seconds, between when OSPF receives 

information that will require an SPF 

calculation and when it starts an SPF 

calculation. The valid range for 

delay_integer is 0 to 4294967295.
The hold_integer is the minimum time, 

in seconds, between consecutive SPF 

calculations. The valid range for 

hold_integer is 0 to 4294967295.
OSPF updates routes more quickly if the 

SPF timers are set low; however, this uses 

more CPU. A setting of 0 for spf-timers 

can quickly use up all available CPU.

5 10

All models.