Fortinet fortigate-200a Betriebsanweisung

Type G to get the new firmware image from the TFTP server.
The following message appears:
Enter TFTP server address [192.168.1.168]:

Type the address of the TFTP server and press Enter.
The following message appears:
Enter Local Address [192.168.1.188]:

Type an IP address that can be used by the FortiGate unit to connect to the FTP 
server.
The IP address must be on the same network as the TFTP server, but make sure you 
do not use the IP address of another device on this network.
The following message appears:
Enter File Name [image.out]:

Enter the firmware image file name and press Enter.
The TFTP server uploads the firmware image file to the FortiGate unit and messages 
similar to the following appear.
• FortiGate unit running v2.x BIOS

Do You Want To Save The Image? [Y/n]
Type N.

• FortiGate unit running v3.x BIOS

Save as Default firmware/Run image without saving:[D/R]
or
Save as Default firmware/Backup firmware/Run image without 
saving:[D/B/R]

Type R.

The FortiGate image is installed to system memory and the FortiGate unit starts 
running the new firmware image but with its current configuration. 

You can log into the CLI or the web-based manager using any administrative account.

To confirm that the new firmware image has been loaded, from the CLI enter:
get system status
You can test the new firmware image as required.

If the FortiGate unit is running BIOS version v3.x, you can install a backup firmware 
image. Once the backup firmware image is installed you can switch to this backup 
image when required.

•

•

•