Fortinet fortigate-200a Betriebsanweisung

The VLAN ID can be any number between 1 and 4096 and must match the VLAN ID 
added by the IEEE 802.1Q-compliant router or switch connected to the VLAN 
subinterface.

For more information on VLANs, see 

Select a virtual domain to add the interface or VLAN subinterface to this virtual 
domain. Virtual domain is only available if you have added a virtual domain.

For more information on virtual domains, see 

Select Manual, DHCP, or PPPoE to set the addressing mode for this interface.

Select Manual and enter an IP address and netmask for the interface. The IP address 
of the interface must be on the same subnet as the network the interface is connecting 
to.

Two interfaces cannot have the same IP address and cannot have IP addresses on 
the same subnet.

If you configure the interface to use DHCP, the FortiGate unit automatically 
broadcasts a DHCP request. You can disable Connect to server if you are configuring 
the FortiGate unit offline and you do not want the FortiGate unit to send the DHCP 
request.

Note: Where you can enter both an IP address and a netmask in the same field, you can use 
the short form of the netmask. For example, 192.168.1.100/255.255.255.0 can also be entered 
as 192.168.1.100/24.

Enter the administrative distance for the default gateway retrieved from 

the DHCP server. The administrative distance, an integer from 1-255, 

specifies the relative priority of a route when there are multiple routes 

to the same destination. A lower administrative distance indicates a 

more preferred route. The default distance for the default gateway is 1.

Enable Retrieve default gateway from server to retrieve a default 

gateway IP address from the DHCP server. The default gateway is 

added to the static routing table.

Override internal DNS Enable Override internal DNS to use the DNS addresses retrieved 

from the DHCP server instead of the DNS server IP addresses on the 

DNS page.

Enable Connect to Server so that the interface automatically attempts 

to connect to a DHCP server. Disable this option if you are configuring 

the interface offline.

Displays DHCP status messages as the FortiGate unit connects to the 

DHCP server and gets addressing information. Select Status to refresh 

the addressing mode status message. 

No activity.