Fortinet fortigate-100a Betriebsanweisung

In the list of tunnels, select the Bring down tunnel or Bring up tunnel button in the row 
that corresponds to the tunnel that you want to bring down or up.

The dialup monitor lists status information for all active dialup VPN tunnels. The 
number of tunnels on the list changes as dialup users connect and disconnect from 
the FortiGate unit.

The static IP and dynamic DNS monitor provides information about VPN connections 
to remote static and dynamic DNS IP addresses. You can use this list to view status 
and IP addressing information for each tunnel configuration.

Note: If you take down an active tunnel while a dialup client such as FortiClient is still 
connected, FortiClient will continue to show the tunnel connected and idle. The dialup client 
must disconnect before another tunnel can be initiated.

Stop all dialup tunnels and stop the traffic passing through all dialup tunnels. 

Dialup users may have to re-connect to establish new VPN sessions.

The name of the phase 2 for the dialup tunnel followed by the number of the 

dialup tunnel. For example, if there are 4 dialup tunnels running that use a 

phase 2 configuration named Dial_tunnel, the dialup tunnels would be 

named Dial_tunnel_1, Dial_tunnel_2, and Dial_tunnel_3.

Remote gateway The IP address and UDP port of the dialup remote gateway.
Username

The XAUTH user name if XAUTH is enabled for the VPN tunnel. See 

.

The time before the next key exchange. The time is calculated by 

subtracting the time elapsed since the last key exchange from the keylife.

Proxy ID Source The IP address range that the dialup user can connect to. 
Proxy ID 
Destination

The IP address range from which the dialup user can connect. This is 

usually the current IP address of the dialup user’s computer.

Stop the current dialup tunnel. The dialup user may have to reconnect to 

establish a new VPN session.