Fortinet fortigate-200a Betriebsanweisung

To change to NAT/Route mode:

Go to System > Status > Status.

In the Operation Mode field of the Unit Information section, select Change.

In the Operation Mode field, select NAT/Route.

Select OK.
The FortiGate unit changes operation mode.

To reconnect to the web-based manager, you must connect to the interface 
configured by default for management access.
By default in NAT/Route mode, you can connect to port1. The default port1 IP address 
is 192.168.1.99.

The session list displays information about the communications sessions currently 
being processed by the FortiGate unit. You can use the session list to view current 
sessions. 

Note:  If the management IP address was on a different subnet in Transparent mode, you may 
have to change the IP address of your computer to the same subnet as the interface configured 
for management access.

Set source IP address for list filtering

Set source port for list filtering

Set destination IP address for list filtering

Set destination port for list filtering

Select to filter session list 

Virtual Domain Select a virtual domain to list the sessions being processed by that virtual 

domain. Select All to view sessions being processed by all virtual domains.

Total number of sessions currently being conducted through the FortiGate 

unit.

Refresh icon. Select to update the session list
Page up icon. Select to view previous page in the session list
Page down icon. Select to view the next page in the session list.

The service protocol of the connection, for example, udp, tcp, or icmp.

The source IP address of the connection.

The source port of the connection.

The destination IP address of the connection.