Fortinet fortigate-200a Betriebsanweisung

Go to System > Network > Routing Table.

Select Create New to add a new route.

Set the Destination IP and Mask to 0.0.0.0.
For the default route, set the Destination IP and Mask to 0.0.0.0.

Set Gateway to the IP address of the next hop routing gateway.
For an Internet connection, the next hop routing gateway routes traffic to the Internet.

Select OK to save the route.

A VLAN is group of PCs, servers, and other network devices that communicate as if 
they were on the same LAN segment, even though they may not be. For example, the 
workstations and servers for an accounting department could be scattered throughout 
an office, connected to numerous network segments, but they can still belong to the 
same VLAN.

A VLAN segregates devices logically instead of physically. Each VLAN is treated as a 
broadcast domain. Devices in VLAN 1 can connect with other devices in VLAN 1, but 
cannot connect with devices in other VLANs. The communication among devices on a 
VLAN is independent of the physical network.

A VLAN segregates devices by adding 802.1Q VLAN tags to all of the packets sent 
and received by the devices in the VLAN. VLAN tags are 4-byte frame extensions that 
contain a VLAN identifier as well as other information.

VLANs allow highly flexible, efficient network segmentation, enabling users and 
resources to be grouped logically, regardless of physical locations.

Enter the destination IP address and netmask for this route.

Enter the IP address of the next hop router to which this route directs traffic

The the relative preferability of this route. 1 is most preferred.

Note: Only one default route can be active at a time. If two default routes are added to the 
routing table, only the default route closest to the top of the routing table is active.