Fortinet FortiGate 4000 Betriebsanweisung

Go to Router > Policy Route.

Select Create New to add a new policy route or select the edit icon beside an existing 
policy route to edit that policy route.

Optionally enter a Protocol number.

Select the Incoming Interface.

Enter the Source Address / Mask and the Destination Address / Mask.

Optionally enter the Destination Ports.

Select the Outgoing Interface.

Enter the Gateway Address.

Select OK.

The FortiGate implementation of the Routing Information Protocol (RIP) supports both 
RIP version 1 as defined by RFC 1058, and RIP version 2 as defined by RFC 2453. 
RIP version 2 enables RIP messages to carry more information, and to support simple 
authentication and subnet masks.

Match packets that have this protocol number.

Incoming Interface Match packets that are received on this interface.
Source Address / 
Mask

Match packets that have this source IP address and netmask.

Match packets that have this destination IP address and netmask.

Match packets that have this destination port range. To match a single 

port, enter the same port number for both From and To.

Outgoing Interface Send packets that match this policy route, out this interface.
Gateway Address

Send packets that match this policy route to this next hop router.