Fortinet fortigate-300 Installationsanweisungen
Getting started
Planning the FortiGate configuration
FortiGate-300 Installation Guide
01-28004-0021-20040830
23
You can use the web-based manager GUI, the control buttons and LCD, or the
command line interface (CLI) for the basic configuration of the FortiGate unit. You can
use the web-based manager setup wizard for easy configuration of a few more
advanced settings.
command line interface (CLI) for the basic configuration of the FortiGate unit. You can
use the web-based manager setup wizard for easy configuration of a few more
advanced settings.
Web-based manager
You can configure most basic and advanced setting from the web-based manager
GUI.
GUI.
CLI
If you are configuring the FortiGate unit to operate in NAT/Route mode, you can add
the administration password and all interface addresses using the CLI. You can also
add DNS server IP addresses and a default route for the external interface.
the administration password and all interface addresses using the CLI. You can also
add DNS server IP addresses and a default route for the external interface.
Additionally, you can use the CLI to configure the external interface for either a
manual (static) or a dynamic (DHCP or PPPoE) address. You can change the
configuration of the FortiGate DHCP server to supply IP addresses for the computers
on your internal network.
manual (static) or a dynamic (DHCP or PPPoE) address. You can change the
configuration of the FortiGate DHCP server to supply IP addresses for the computers
on your internal network.
If you are configuring the FortiGate unit to operate in Transparent mode, you can use
the CLI to switch to Transparent mode. Then you can add the administration
password, the management IP address and gateway, and the DNS server addresses.
the CLI to switch to Transparent mode. Then you can add the administration
password, the management IP address and gateway, and the DNS server addresses.
Front control buttons and LCD
If you are configuring the FortiGate unit to operate in NAT/Route mode, you can use
the control buttons and LCD to add the IP address of the FortiGate interfaces as well
as the external default gateway.
the control buttons and LCD to add the IP address of the FortiGate interfaces as well
as the external default gateway.
If you are configuring the FortiGate unit to operate in Transparent mode, you can use
the control buttons and LCD to switch to Transparent mode. Then you can add the
management IP address and default gateway.
the control buttons and LCD to switch to Transparent mode. Then you can add the
management IP address and default gateway.
Setup wizard
If you are configuring the FortiGate unit to operate in NAT/Route mode (the default),
you can use the setup wizard to:
you can use the setup wizard to:
• add the administration password
• configure the internal interface address
• choose either a manual (static) or a dynamic (DHCP or PPPoE) address for the
• configure the internal interface address
• choose either a manual (static) or a dynamic (DHCP or PPPoE) address for the
external interface
• add a default route for the external interface
• add the DNS server IP addresses
• add the DHCP server settings and IP addresses
• add various internal server IP addresses including web, IMAP, POP3, SMTP, and
• add the DNS server IP addresses
• add the DHCP server settings and IP addresses
• add various internal server IP addresses including web, IMAP, POP3, SMTP, and
FTP servers
• set the antivirus protection to high, medium, or none