Fortinet fortigate-50r Installationsanweisungen

Add an address to which PPTP users can connect.

Go to Firewall > Address.

Select the internal interface or the DMZ interface. (Methods will differ slightly between 
FortiGate models.)

Select New to add an address.

Enter the Address Name, IP Address, and NetMask for a single computer or for an 
entire subnetwork on an internal interface of the local VPN peer.

Select OK to save the source address.

Add a policy which specifies the source and destination addresses and sets the 
service for the policy to the traffic type inside the PPTP VPN tunnel.

Go to Firewall > Policy.

Select New to add a new policy.

Set Source to the group that matches the PPTP address range.

Set Destination to the address to which PPTP users can connect.

Set Service to match the traffic type inside the PPTP VPN tunnel. 
For example, if PPTP users can access a web server, select HTTP.

Set Action to ACCEPT.

Select NAT if address translation is required.
You can also configure traffic shaping, logging, and antivirus and web filter settings for 
PPTP policies.

Select OK to save the firewall policy.

Use the following procedure to configure a client computer running Windows 98 so 
that it can connect to a FortiGate PPTP VPN. To configure the Windows 98 client, you 
must install and configure Windows dialup networking and virtual private networking 
support.

Go to Start > Settings > Control Panel > Network.

Select Add.

Select Adapter.

Select Add.

Select Microsoft as the manufacturer.

Select Microsoft Virtual Private Networking Adapter.

Select OK twice.

Insert diskettes or CDs as required.