Fortinet fortigate-50r Installationsanweisungen

As an alternative to using the setup wizard, you can configure the FortiGate unit using 
the command line interface (CLI). To connect to the CLI, see 

.

Use the information that you gathered in 

 to complete the 

following procedures.

Log into the CLI if you are not already logged in.

Set the IP address and netmask of the internal interface to the internal IP address and 
netmask that you recorded in 

. Enter:

set system interface internal mode static ip <IP address> 

<netmask>

set system interface internal mode static ip 192.168.1.1 

255.255.255.0

Set the IP address and netmask of the external interface to the external IP address 
and netmask that you recorded in 

To set the manual IP address and netmask, enter:

set system interface external static ip <IP address> <netmask>

set system interface external mode static ip 204.23.1.5 

255.255.255.0

To set the external interface to use DHCP, enter:

set system interface external mode dhcp connection enable

To set the external interface to use PPPoE, enter:

set system interface external mode pppoe username <user name> 

password <password> connection enable

set system interface external mode pppoe username 

user@domain.com password mypass connection enable

Confirm that the addresses are correct. Enter:

get system interface

The CLI lists the IP address, netmask and other settings for each of the FortiGate 
interfaces.

Set the primary DNS server IP addresses. Enter

set system dns primary <IP address>

set system dns primary 293.44.75.21

Optionally, set the secondary DNS server IP addresses. Enter

set system dns secondary <IP address>

set system dns secondary 293.44.75.22