Sherwood RD-6504 Benutzerhandbuch
E
N
G
L
IS
H
15
Operations
LISTENING TO A PROGRAM SOURCE
Before operation
• Enter the standby mode.
• The STANDBY indicator lights up.
This means that the receiver is not
disconnected from the AC mains and a
small amount of current is retained to
support the operation readiness.
disconnected from the AC mains and a
small amount of current is retained to
support the operation readiness.
• To switch the power off, push the POWER
switch again.
• Then the power is cut off and the STANDBY
indicator goes off.
• Each time the POWER ON/STANDBY button on the front
panel is pressed, the receiver is turned on to enter the
operating mode or off to enter the standby mode.
operating mode or off to enter the standby mode.
• On the remote control, press the POWER ON button to
enter the operating mode or press the STANDBY button
to enter the standby mode.
to enter the standby mode.
• In the standby mode, if the INPUT SELECTOR button is
pressed, the receiver is turned on automatically and the
desired input is selected.
desired input is selected.
• Each time the "VIDEO" button on the front panel is
pressed, the input source changes as follows:
VIDEO 1
↔ VIDEO 2
• Each time the "AUDIO" button on the front panel is
pressed, the input source changes as follows:
→ CD →AUX → F. AUX → TAPE → BT IN
• Each time the "BAND" button is pressed, the band
changes as follows:
→ FM ST → FM MONO → AM
■
When selecting the EXTERNAL IN as desired,
• "EXT IN" is displayed and 6 separate analog signals
from the component connected to this input pass
through the tone and the volume circuits only and can
be heard from your speakers.
through the tone and the volume circuits only and can
be heard from your speakers.
• Select the desired input source to cancel the external in
function.
• These analog signals can be heard only, not recorded.
or
o r
PO W ER
1.
In the standby mode, turn the power on.
• Then the SPEAKER indicator lights up and the sound
can be heard from the speakers connected to the
speaker terminals.
speaker terminals.
• When using the headphone for private listening, press
the SPEAKER button again to switch the speakers off.
2.
Switch the speakers on.
3.
Select the desired input source.
■Note : Before operating this receiver, first set this unit as desired for optimum performance, doing the system setup
procedures. (For details, refer to "System Setup" on page 29.)
o r
RD-6504(A)_ENG:RD-6504(A)2009-02-12오 9:03페이지15