Sonance fms530 Betriebsanweisung

2. Run the speaker wires from the amplifier to the speaker

locations and through the holes in the mounting brackets.

Note: To increase water resistance and make installation easier,

the speaker wire terminals are located on the FastMount speakers’

front panel. Be sure to leave enough wire at the speaker location

to feed through the tunnel in the speaker enclosure and connect to

the terminals on the front.

3. Attach the mounting bracket to the mounting surface using

hardware (not included) that is appropriate for the type of

surface.

• If the installation requires

that the speakers be mount-

ed in a corner, attach the

brackets with hardware

through the slots in the

angled corners as shown to

the right.

4. If the installation requires that

the speakers be mounted on

poles you can attach the

brackets to poles using 2½”

U-bolts (not included).

5. Feed the speaker wires from

the brackets into the wire

entry grommets on the backs

of the speakers, through the

wire tunnels and out the

openings on the speakers’

front panels.

•

The grommet forms a

water-resistant seal around

the speaker wire.

• Make sure there is

enough slack in the

wire to allow the

speaker to pivot on

the bracket.

Slide the speakers

onto the brackets until

the locks snap into place (see illustration, next column).

• Pull enough wire through the front of the speaker to allow

connection to the terminals.

7. Connect the speaker wires to the speakers’ terminals:

a. Strip ¼” – ½” of insulation from each conductor and

twist the strands together.

b. Unscrew one of the “+” terminals and one of the “–”

terminals (see illustration, below). The two left-hand ter-

minals are “+” and the two right-hand ones are “–”.

c. Insert the wires behind the terminal screws and tighten

the screws to secure the wires.

IMPORTANT: Be sure not to let any stray ‘+’ and ‘–’ wires touch

each other. Touching wires can cause a short-circuit that

could damage your amplifier.

• Double-check that you connected all of the wires properly

(amplifier ‘+’ to speaker ‘+’; amplifier ‘–’ to speaker ‘–’) at

all connections.

• There is an extra set of ”+” and “–” terminals that

allow you to daisy-chain multiple speakers from a single

amplifier connection.

8. Determine the proper wattage setting

for each speaker in the installation

and set each speaker’s transformer

tap selector (see illustration, right)

accordingly.

9. Fit the wiring terminal covers into the

recesses in the speakers’ front

panels (see illustration, next page).

The covers should fit tightly, but can be removed and

replaced if the speakers need to be disconnected.

4. Attaching the
bracket to a pole

5. Wire

entry

grommet

6. Attach speakers
to brackets

3. Corner

mounting

3. Attach

bracket

I N S T R U C T I O N M A N U A L

F A S T M O U N T

S E R I E S

WEATHER-RESISTANT SPEAKERS

Connection

Terminal