Dwin hd-700 Installationsanweisungen

- 22 -

The size adjustments are the final picture adjustment. They define the size of the picture within the blanking
area  previously  established.  These  adjustments  have  the  impact  of  stretching  and/or  compressing  the
picture. To change the picture size, press “MENU” to call up the Main Menu, and press “6” to access Size
control screen. Use the 

/ / /   directional arrow buttons on the remote until the picture is sized to your

requirements.

Once all of the adjustments have been made to establish the picture parameters, they are saved under a
particular name so that these settings may be quickly recalled at a later time. This allows you to create
different settings for the same input source, for different characteristics such as aspect ratio, blanking, gray
level, etc.

To switch to a different source memory for the same input start at  the  Main  menu  then  press  "7"   for
"Source".  A list of preset memories will appear.  Press the corresponding number to switch to the desired
source memory.

You can also access the "Source" memory list by pressing the "GUIDE" button on the remote control.

In addition to the settings that must be set individually for each input source, the HD-700 has a number of
global settings that address certain aspects of the projector’s operation. They should be adjusted to the
preferences of the end user before the set is delivered.

This setting permits the HD-700 to turn on automatically whenever a sync signal is present at the “H/C” input.
This means that it will be in a standby mode when no signal is present, and it will instantly display a picture
when you turn on the feed device such as a computer, decoder, doubler, quadrupler or multiplier. When the
signal is removed the picture will go dark and the unit will return to a standby mode.

To place the unit in the “Auto” mode, press “MENU” and then Press “9” to go to the Set Up menu. Check to
see that the word  “Auto” is highlighted. If it is, the unit is already in the automatic mode and no further
adjustment is required. If the word “Manual” is highlighted, press   to change the setting.

To move the unit back into the  “Manual” mode, press 

 until the word  “Manual”  is highlighted. In this

condition the projector must be manually turned on with the remote control each time it is used.
2.  Menu Access

1.  Name: Anamorphic

31.5KHz   60Hz

2.  Name: Letterbox

31.5KHz   60Hz

- Set Up -                              HD700-45-FF                                Source

         DVD

1.   Power On:

Manual

2.   Menu Access:

Protected

3.   Direct Source:

Off

4.   Mounting:

FC

RF

RC

5.  Copy, Rename, or Delete Video Memory

Use 

Ω

  or  

ς

 to change preferences.