Hitachi c10fcb miter saw Benutzerhandbuch

17

  7. Crown molding cutting procedures

Fig. 21 shows two common crown molding types having angles of (

θ

) 38° and 45°.

For the typical crown molding fittings, see Fig. 21.

Fig. 20

Fig. 21

The table below shows the miter angle and the bevel angle settings that are ideal for the two crown
molding types.

For miter cut setting

If the table has been set to either of the angles described, move the table adjusting miter handle a little
to the right and left to stabilize the position and to properly align the miter angle scale and the tip of the
indicator before the operation starts.

For bevel cut setting

Move handle on bevel section to the right and left and check that the position is stable and that the
bevel angle scale and the tip of the indicator are properly aligned. Then tighten the clamp lever.

Type of

To process crown molding at

To process crown molding at

Crown Molding

positions 1 and 4 in Fig. 21.

positions 2 and 3 in Fig. 21.

Miter Angle

Bevel Angle

Miter Angle

Bevel Angle

Setting

Setting

Setting

Setting

45° Type

right  35.3°

30°

left 35.3°

30°

(   mark)

(   mark)

38° Type

right  31.6°

33.9°

left 31.6°

33.9°

(   mark)

(   mark)

(   mark)

(   mark)

(1) Setting to cut crown moldings at positions q and r in Fig. 21 (see Fig. 22):

q Turn the table to the right and set the Miter Angle as follows:

* For 45°

type crown moldings: 35.3° (   mark)

* For 38°

type crown moldings: 31.6° (   mark)

w Tilt the head to the left and set the Bevel Angle as follows:

* For 45°

type crown moldings: 30°

* For 38°

type crown moldings: 33.9° (   mark)

e Position the crown molding so that the upper surface (A in Fig. 20) contacts the fence as indicated

in Fig. 24.

Ceiling

Wall

q

w

e

r

Wall

A upper surface

Ceiling

B lower surface

θ

°