Hitachi 7K1000 Installationsanweisungen

Page 1 

 

 

 

 

 

 

 

 

 

 

 

 

Quick installation guide   

 

Hitachi Deskstar 7K1000 

Serial ATA Hard disk drive 
 

Models: HDS721010KLAT60 

HDS721075KLAT60 
HDS721010KLA330 
HDS721075KLA330 

 
 

 

The following are needed to install a Serial ATA drive to 
a system.  

 

Serial ATA capable motherboard or controller card  

 

Serial ATA drive 

 

Serial ATA cable (1 meter or less in length) 

Set the drive down gently to prevent damage from 
impact or vibration.   
•  Do not open the ESD bag containing the drive 

until needed. 

•  Handle the drive carefully by the edges. Do not 

touch the exposed printed circuit board or any 
electronic components. 

•  Do not press on the top or bottom of the drive. 

•  Before handling the drive, discharge any static 

electricity from yourself and your clothing. With 
one hand touch an unpainted metal surface on 
your computer chassis, then touch the ESD bag 
with the other hand. Remain in contact with the 
chassis and the bag for a minimum of two 
seconds. 

 

Quick installation procedure 

Note:  Back up all data before installing drive! 

1.  Turn off the computer. 

2.  Unplug the computer. 
3.  Remove the computer cover as instructed by the 

computer system manual. 

4.  Discharge static electricity (see Handling pre-

cautions). 

5.  Note the mounting position of existing drives and 

cables. If you are replacing a drive or any cable, 
remove it now. 

6.  Remove the drive from the ESD bag. 
7.  Record the model, the part number, and the serial 

number of the drive for future reference. 

8.  Attach the Serial ATA cable to the drive. Match 

key on cable to connector on drive  

 

Connect Power Connector 
Connect Serial ATA power connector if provided on 
power supply or use legacy 4 pin power connector.  
Arrange cable to match connector as shown in photos 
below.