Delfield rffsc-103 Техническое Руководство

Delfield reserves the right to make changes in design or specifications without prior notice. ©2002 The Delfield Company. All rights reserved. Printed in U.S.A. 

The exterior sides and top edge shall be 20-gauge galvanized steel. 

Exterior bottom to be 14-gauge galvanized steel.

Interior shall have (2) separate compartments, one refrigerated and one 

freezer. Inner liners shall be water-tight and constructed of 22-gauge 

stainless steel with a 1.25" (3.2cm) I.P.S. drain. Openings shall have 

throat liners constructed of high impact plastic. Unit to be insulated 

with foamed-in-place polyurethane insulation with a non-conductive top 

breaker strip. 

Each opening shall have an insulated, stainless steel folding lid with 

high impact plastic liner, molded rubber edge and black plastic handles.

(1) stainless steel louver shall be provided for installation in the cabinet 

to allow proper air flow to the condensing unit.

Each self-leveling mechanism shall be field adjustable by adding or 

removing stainless steel extension springs in the elevator housing inside 

the unit. The elevators shall be connected by removable platform carriers 

constructed of 18-gauge stainless steel.

(6) anodized aluminum divider trays will be supplied per opening. 

NOTE: See chart on back for ice cream storage capacity.

Refrigeration system shall use HFC-404A refrigerant. Refrigerant flow 

shall be controlled by an (2) expansion valves. Cabinet shall maintain 

36°F to 40°F (2°C to 4°C) temperature in the refrigerator section and 

0°F to 5°F (–18°C to –15°C) temperature in the freezer section with lids 

closed for storage.

Refrigerator section shall be controlled by an EPR valve; the freezer 

section shall be controlled by a pressure control. Controls shall be 

located near the condensing unit.

Electrical connections shall be 115 volt, 60 cycle, single phase. Unit 

shall have a 9' (2.7m) long electrical cord and NEMA 5-15P installed at 

the mechanical end.

  •   Lid locking device

  •   Wire baskets

  •   Lexan

®

 lids (refrigerated compartment only)

  •   Inclusion of this option will alter the electrical specifications of the 

unit. Special voltages (contact factory)

Model RFFSC-103