Canon S830D Anleitung Für Quick Setup
68
Troubleshooting
Handling Error Messages While Using the Operation Panel
If an error number is displayed on the Operation Panel, correct the error according
to the procedure below.
to the procedure below.
If the display or buttons on the Operation Panel are not operating
properly, even though an error is not displayed, turn off the printer,
unplug the power cord, and then turn on the printer again.
properly, even though an error is not displayed, turn off the printer,
unplug the power cord, and then turn on the printer again.
The color of the ink tank affected by the error can be checked in
Media Type. An error has occurred in the ink tank indicated by the
blinking position.
Media Type. An error has occurred in the ink tank indicated by the
blinking position.
Error
Number
Problem
Try This
001
Printer is
being used
being used
Printing starts when printing from the computer is completed. Press
the Cancel button to stop printing.
the Cancel button to stop printing.
002
Printer is not ready
Wait until preparations are completed. Printing will start when
preparations are completed.
preparations are completed.
101
Ink level is low
Prepare a replacement ink tank. Press the Print button to restart
printing even though the print level is low. Printing will start when the
ink tank is replaced. Press the Cancel button to stop printing.
printing even though the print level is low. Printing will start when the
ink tank is replaced. Press the Cancel button to stop printing.
102
Position of paper
thickness lever is
incorrect
thickness lever is
incorrect
Printing will start when you set the paper thickness lever to the correct
position. Press the Print button to start printing with paper thickness
lever position that is currently set. Press the Cancel button to stop
printing.
position. Press the Print button to start printing with paper thickness
lever position that is currently set. Press the Cancel button to stop
printing.
103
Position of paper
thickness lever is
incorrect and ink
level is low
thickness lever is
incorrect and ink
level is low
Prepare a replacement ink tank. Replace the ink tank, and set the
paper thickness lever to the correct position to start printing. Press the
Print
paper thickness lever to the correct position to start printing. Press the
button to restart printing under the current conditions.
201
Ink has run out
Press the Cancel button to stop printing, and then replace the ink tank.
Press the RESUME/CANCEL button on the printer to start printing
without any ink.
Press the RESUME/CANCEL button on the printer to start printing
without any ink.
202
Waste ink tank
is full
is full
Press the RESUME/CANCEL button on the printer to restart printing.
Immediately contact the Canon Customer Care Center and request
replacement of the waste ink absorber.
Immediately contact the Canon Customer Care Center and request
replacement of the waste ink absorber.
301/302
No paper, paper
cannot be fed, or
paper jam
cannot be fed, or
paper jam
Load paper correctly, and press the RESUME/CANCEL button on the printer
to start printing. If a sheet is jammed, remove the jammed sheet, load paper
correctly, and then press the RESUME/CANCEL button on the printer.
to start printing. If a sheet is jammed, remove the jammed sheet, load paper
correctly, and then press the RESUME/CANCEL button on the printer.
S830D QSG.book Page 68 Monday, April 29, 2002 4:30 PM