LXE mx7 Verweisanleitung

86 

Start Menu Program Options 

MX7 Reference Guide 

 

E-EQ-MX7RG-H 

Summit automatically installs and runs after every cold and warm boot.  

Tap the Disable Radio button. The wireless device is enabled by default after every cold reset.  

When the wireless device is disabled, tap the Enable Radio button. The wireless device is 
enabled by default after every cold reset.  

See Chapter 5 “Wireless Network Configuration” for Summit Client Utility setup information and 
instruction. 

Contents of README.TXT file are located in Start | Programs | Summit | Certs menu option:   

CA Certificate files, user certificate files and PAC files are accessed only from this 
location. When entering the certificate filenames in the Summit Client Utility (SCU), 
only the filename and extension are entered. Only PEM, DER and PFX extensions are 
allowed for certificate files. 

See Chapter 5 “Wireless Network Configuration” for directions for acquiring CA and user 
certificate files. 

This utility has an icon in the toolbar that looks like networked computers with a red X through 
them, indicating the application is enabled and the MX7 is not connected to a network.  

If you will be using the Wireless Zero Config Utility to configure the network card, or connect to 
a network, perform the following steps: 

1.  Tap the Summit Client Utility icon on the desktop, or tap Start | Programs | Summit | 

SCU. 

2.  Select ThirdPartyConfig in the Active Config drop down box. 
3.  A message appears that a Power Cycle is required to make settings activate properly. Tap 

OK to close the message window. 

4.  Tap the Power button to place the MX7 in Suspend, then tap the Power button to wake 

the MX7 from Suspend mode.  

The Wireless Zero Config utility begins.