LXE mx7 Verweisanleitung
122
Settings | Control Panel Options
MX7 Reference Guide
E-EQ-MX7RG-H
Password
Access:
| Settings | Control Panel | Password Icon
Set MX7 user access/power up password properties. Password and password settings are saved
during a warm boot and a cold boot. The screensaver password affects the Remote Desktop
screensaver only.
during a warm boot and a cold boot. The screensaver password affects the Remote Desktop
screensaver only.
Factory Default Settings
Password Blank
Enter at Power On
Enter at Power On
Disabled
Enter at Screen Saver
Disabled
Note:
Once a password is assigned, each Settings option requires the password be entered
before each Settings option can be accessed.
before each Settings option can be accessed.
Figure 3-30 Password
Enter the password in the Password textbox, then type it again to confirm it.
Enable the power-on checkbox and, if desired, the screensaver checkbox. Tap the OK button to
save the changes. The password is in effect immediately.
save the changes. The password is in effect immediately.
The screensaver password is the same as the power-on password. They are not set independently.
A screensaver password cannot be created without first enabling the “Enable password protection
at power-on” checkbox. The screensaver password is not automatically enabled when the “power-
on” checkbox is enabled.
A screensaver password cannot be created without first enabling the “Enable password protection
at power-on” checkbox. The screensaver password is not automatically enabled when the “power-
on” checkbox is enabled.
Troubleshooting
The password must be entered before performing a coldboot or cold reset. If entering a power-on
or screensaver password will not allow you to disable password protection or run COLDBOOT,
contact LXE Technical Support.
or screensaver password will not allow you to disable password protection or run COLDBOOT,
contact LXE Technical Support.