LXE mx7 Verweisanleitung
Main Tab
173
E-EQ-MX7RG-H
MX7 Reference Guide
If “Send Key Messages …” is checked any data scan is converted to keystrokes and sent to the
active window. When this box is not checked, the application will need to use the set of LXE
Scanner APIs to retrieve the data from the scanner driver. Note that this latter method is
significantly faster than using “Wedge”.
active window. When this box is not checked, the application will need to use the set of LXE
Scanner APIs to retrieve the data from the scanner driver. Note that this latter method is
significantly faster than using “Wedge”.
Disable “Enable Internal Scanner Sound” when you want an application, not the scan engine or
the CE operating system, to control scanner audible notifications. Adjust the settings and tap the
OK box to save the changes. The changes take effect immediately.
the CE operating system, to control scanner audible notifications. Adjust the settings and tap the
OK box to save the changes. The changes take effect immediately.
Main Tab
Access:
| Settings | Control Panel | Scanner | Main tab
Factory Default Settings
Main
Port 1
Port 1
Internal
Port 2
Disabled
Port 3
Disabled
Send key messages (WEDGE)
Enabled
Enable Internal Scanner Sound
Enabled
* Good Scan Vibration
Disabled / Long
* Bad Scan Vibration
Disabled / Long
Figure 4-3 Scanner Control / Main
* Vibration checkboxes previously on the Main tab panel are located on the Vibration tab panel.
Adjust the settings and tap the OK box to save the changes. The changes take effect immediately.
Parameter Function
Port
Port 1 – Internal. Radio button allows scanner input/output on Port 1
(scan key or trigger).
(scan key or trigger).
Port 2 – Output is enabled when COM1 is enabled on this port.
Port 3 - Output is enabled when COM1 is enabled on this port.
Send Key Messages
(WEDGE)
(WEDGE)
When Send Key Messages (WEDGE) is checked any data scan is
converted to keystrokes and sent to the active window. When this box is
not checked, the application will need to use the set of LXE Scanner
APIs to retrieve the data from the scanner driver. Note that this latter
method is significantly faster than using “Wedge”.
converted to keystrokes and sent to the active window. When this box is
not checked, the application will need to use the set of LXE Scanner
APIs to retrieve the data from the scanner driver. Note that this latter
method is significantly faster than using “Wedge”.