LXE mx7 Verweisanleitung
Barcode Tab
177
E-EQ-MX7RG-H
MX7 Reference Guide
Buttons
Symbology
Settings
Settings
Individually enable or disable a barcode from being scanned, set the minimum
and maximum size barcode to accept, strip Code ID, strip data from the
beginning or end of a barcode, or (based on configurable Barcode Data) add a
prefix or suffix to a barcode before transmission.
and maximum size barcode to accept, strip Code ID, strip data from the
beginning or end of a barcode, or (based on configurable Barcode Data) add a
prefix or suffix to a barcode before transmission.
Ctrl Char
Mapping
Mapping
Define the operations the LXE Wedge performs on control characters (values
less than 0x20) embedded in barcodes.
less than 0x20) embedded in barcodes.
Custom
Identifiers
Identifiers
Defines an identifier that is at the beginning of barcode data which acts as a
Code ID. After a Custom Identifier is defined, Symbology Settings can be
defined for the identifier just like standard Code IDs.
Code ID. After a Custom Identifier is defined, Symbology Settings can be
defined for the identifier just like standard Code IDs.
See Also: Barcode Processing Overview earlier in this chapter.
Continuous Scan Mode
Access:
| Settings | Control Panel | Scanner | Barcode tab
Enabling Continuous Scan Mode will ensure the laser is always on and decoding.
Caution: Laser beam is emitted continuously. Do not look or stare into the laser beam.
Factory Default Settings
Continuous Scan
Continuous Scan Mode
Continuous Scan Mode
Disabled
Timeout between same symbol
1 second
Set the Timeout between same symbol to a value sufficient to prevent the beeper from
continuously beeping when a symbol is left in the scanner’s field of view.
continuously beeping when a symbol is left in the scanner’s field of view.
If trigger mode, power mode, or timeout between same symbol parameters are changed using
external configuration barcodes in the Integrated Scanner Programming Guide, the operating
system automatically restores the parameters to their programmed settings upon a warm or cold
boot and/or any change made in the control panel.
external configuration barcodes in the Integrated Scanner Programming Guide, the operating
system automatically restores the parameters to their programmed settings upon a warm or cold
boot and/or any change made in the control panel.
When the scanner is in continuous mode the trigger and scan buttons function as a scanner On/Off
switch.
switch.
The scanner red LED will always be off in continuous mode. The audio beeps and green LED
work the same as they do for normal trigger mode.
work the same as they do for normal trigger mode.
Switching to and from continuous and normal trigger modes is in effect immediately upon
pressing the OK button in this control panel, a warm boot is not required or necessary.
pressing the OK button in this control panel, a warm boot is not required or necessary.