LXE mx7 Verweisanleitung

282 

Setup a New Device 

MX7 Reference Guide 

 

E-EQ-MX7RG-H 

• 

The touch panel must be enabled.  

• 

An MX7 default input method (Input Panel, Transcriber, or custom input method) is 
assigned. 

LXE CE devices with the AppLock feature are shipped to boot in Administration mode with no 
default password, thus when the device is first booted, the user has full access to the device and no 
password prompt is displayed. After the administrator specifies applications to lock, a password is 
assigned and the device is rebooted or the hotkey is pressed, the device switches to end-user 
mode. 

Briefly, the process to configure a new device is as follows: 

1.  Insert a fully charged battery and press the Power button. See Chapter 1 – Introduction 

for instruction. 

2.  Connect an external power source to the device (if required). See Chapter 1 – 

Introduction for instruction. 

3.  Adjust screen display, audio volume and other parameters if desired. Install accessories 

(e.g. handstrap, stylus). See Chapter 1 – Introduction for instruction. 

4.  Tap 

 | Settings | Control Panel | Administration icon. 

5.  Assign a Switch Key (hotkey) sequence for AppLock. See Security Panel. 
6.  Assign an application on the Application tab screen. More than one application can be 

assigned. See Application Panel. 

7.  Assign a password on the Security tab screen. See Security Panel. 
8.  Select a view level on the Status tab screen, if desired. See Status Panel. 
9.  Tap OK. 
10.  Press the hotkey sequence to launch AppLock and lock the configured application(s). 
11.  The device is now in end-user mode.