LXE mx7 Verweisanleitung

Hardware Setup 

15 

E-EQ-MX7RG-H 

 

MX7 Reference Guide 

The MX7 receives AC/DC power from the AC/DC 12V Power Supply. The MX7 external power 
connection is part of the RS-232 cable assembly and the USB cable assembly.  

To apply external power to the MX7 follow the steps below in sequence. 

1.  Plug the 3 prong adapter cable end of the external power module into an AC power source 

(e.g. wall outlet). 

2.  Squeeze the sides of the power connector and push the MX7 power cable connector into 

the MX7 port until it clicks. The click means the connector is seated firmly. 

3.  Press the power cable connector pin from the power adapter into the connector on the 

(USB/Power or RS-232/Power) cable attached to the base of the MX7. AC power is now 
being supplied to the MX7. 

The System LED above the Scan key illuminates when the MX7 is charging the main battery pack 
using external power through the power cable. The backup battery is always being trickle charged 
by the main battery pack.. 

Whenever possible, use the AC power adapter with the MX7 to conserve the main battery power 
and maintain a charge in the backup battery. 

If the AC power cable is not included with the AC Adapter, please contact your LXE 
representative for assistance.  

 

Plug the 3-prong cable into an AC wall outlet. Firmly press the female end of the power cable into 
the male connector on the power adapter. AC power is now being supplied to the power adapter.