LXE mx7 Verweisanleitung
Setup a New Device
315
E-EQ-MX7RG-H
MX7 Reference Guide
Setup a New Device
LXE devices with the AppLock feature are shipped to boot in Administration mode with no
default password, thus when the device is first booted, the user has full access to the device and no
password prompt is displayed. After the administrator specifies a password, an application to lock,
and the device is rebooted or the hotkey is pressed, the mobile device switches to end-user mode.
default password, thus when the device is first booted, the user has full access to the device and no
password prompt is displayed. After the administrator specifies a password, an application to lock,
and the device is rebooted or the hotkey is pressed, the mobile device switches to end-user mode.
Briefly, the process to configure a new device is as follows:
1. Insert a fully charged battery and press the Power button. See Chapter 1 - Introduction.
2. Connect an external power source to the device (if required). See Chapter 1 -
2. Connect an external power source to the device (if required). See Chapter 1 -
Introduction.
3. Adjust screen display, audio volume and other parameters if desired. See Chapter 1 -
Introduction.
4. Tap
| Settings | Control Panel | Administration icon.
5. Assign an application on the Control tab screen. See Control Panel.
6. Assign a password on the Security tab screen. See Security Panel.
7. Select a view level on the Status tab screen, if desired. See Status Panel.
8. Tap OK.
9. Press the hotkey sequence to launch AppLock and lock the configured application. See
6. Assign a password on the Security tab screen. See Security Panel.
7. Select a view level on the Status tab screen, if desired. See Status Panel.
8. Tap OK.
9. Press the hotkey sequence to launch AppLock and lock the configured application. See
Security Panel.
10. The mobile device is now in end-user mode.