LXE vx7 Verweisanleitung
4
Quick Start
VX7 Reference Guide
E-EQ-VX7RG-H
Quick Start
This section’s instructions are based on the assumption that your new system is pre-configured
and requires only accessory installation (e.g. antenna, external keyboard and/or barcode scanner)
and a power source.
and requires only accessory installation (e.g. antenna, external keyboard and/or barcode scanner)
and a power source.
In general, the sequence of events is:
1. Install Vehicle Mounting Bracket on vehicle and secure VX7 in Mounting Bracket
Assembly (see “VX7 User’s Guide”).
2. Connect power cable to the VX7. The power cable can also be connected to a UPS
battery pack, which is then connected to the VX7 (see “VX7 User’s Guide”).
3. Connect accessories to VX7, e.g. scanner, antenna, etc. (see “VX7 User’s Guide).
4. Secure all cables to the VX7 with the Strain Relief Cable Clamps.
5. Turn the VX7 on.
6. When instructed, calibrate the touchscreen (see Chapter 3, “System Configuration”).
7. The screen may appear white while applications and drivers are loading. When
complete, set Date and Time (see Chapter 3, “System Configuration”).
8. Pair Bluetooth devices.
9. Configure radio (see Chapter 5, “Wireless Network Configuration”).
10. Warmboot to ensure all registry settings are saved.
11. Device is ready for use.
The VX7 and its keyboard should be mounted in an area in the vehicle where it:
• Does not obstruct the vehicle driver’s vision or safe vehicle operation.
• Can be easily accessed by anyone seated in the driver’s seat.
• Can be easily accessed by anyone seated in the driver’s seat.
Troubleshooting
Can’t calibrate the
touch screen, change
the date/time or
adjust the volume.
touch screen, change
the date/time or
adjust the volume.
AppLock is installed and running on the mobile device. AppLock
restricts User access to running programs. Changes or modifications
require Administrator access.
restricts User access to running programs. Changes or modifications
require Administrator access.
Refer to “Chapter 6 – AppLock” for setup and processing information.
RFTerm opens and
runs upon each cold
reset and warm reset.
runs upon each cold
reset and warm reset.
Tap File | Exit to close the RFTerm application.
VX7 seems to lockup
as soon as it is
warmbooted.
as soon as it is
warmbooted.
There may be small delays while the wireless client connects to the
network, authorization for Voxware-enabled applications complete,
Wavelink Avalanche management of the VX7 startup completes, and
Bluetooth relationships establish or re-establish.
network, authorization for Voxware-enabled applications complete,
Wavelink Avalanche management of the VX7 startup completes, and
Bluetooth relationships establish or re-establish.