LXE vx3x Verweisanleitung
162
Summit Radio
VX3X Reference Guide
E-EQ-VX3XRG-D
Radio Mode
Specify 802.11a, 802.11b and/or 802.11g rates when communicating with AP. The options
displayed for this parameter depend on the type of radio (802.11b/g or 802.11a/b/g) installed in
the mobile device.
displayed for this parameter depend on the type of radio (802.11b/g or 802.11a/b/g) installed in
the mobile device.
Options:
B rates only (1, 2, 5.5 and 11 Mbps)
BG Rates Full (All B and G rates)
G rates only (6, 9, 12, 18, 24, 36, 48 and 54 Mbps)
BG optimized or BG subset (1, 2, 5.5, 6, 11, 24, 36 and 54 Mbps))
A rates only (6, 9, 12, 18, 24, 36, 48 and 54 Mbps)
ABG Rates Full (All A rates and all B and G rates with A rates preferred)
BGA Rates Full (All B and G rates and all A rates with B and G rates preferred)
Default:
BG Rates Full (for 802.11b/g radio)
BGA Rates Full (for 802.11a/b/g radio)
Note:
For the802.11 b/g radio, some SCU versions may have the default set as BG Optimized
rather than BG Rates Full.
rather than BG Rates Full.
It is important this parameter correspond to the AP to which the device is to connect. For
example, if this parameter is set to G rates only the LXE device may only connect to APs set for G
rates and not those set for B and G rates.
example, if this parameter is set to G rates only the LXE device may only connect to APs set for G
rates and not those set for B and G rates.
The options for this parameter should be set as follows:
Antenna Configuration
Radio Mode
A Main and BG Main
ABG Rates Full
BGA Rates Full
BGA Rates Full
A Main and A Aux
A Rates Only
BG Main and BG Aux
B Rates Only
G Rates Only
BG Rates Full
BG Subset
G Rates Only
BG Rates Full
BG Subset
A Main only (external)
A Rates Only
BG Main only (external)
B Rates Only
G Rates Only
BG Rates Full
BG Rates Subset
G Rates Only
BG Rates Full
BG Rates Subset
Please contact your LXE representative if you have questions about the antenna(s) installed on
your VX3X.
your VX3X.
Auth Type
802.11 authentication type used when associating with AP
Options:
Open
Shared
key
LEAP
Default: Open
Note:
Set the Auth Type radio parameter is set to “Open” for all configurations unless using
LEAP (not WPA) and the AP is configured for network EAP only. In this case, set the
Auth Type radio parameter to “LEAP”.
LEAP (not WPA) and the AP is configured for network EAP only. In this case, set the
Auth Type radio parameter to “LEAP”.