LXE 1390 Installationsanweisungen
Installation Instruction Sheet
Page 3 of 6
E-INS-VEHKBDCHR-B
Cherry Keyboard for LXE DOS Computers
Assemble Keyboard and Interface Cable
Figure 1 Cherry Keyboard and Keyboard Interface Cable
1
4-pin (female) to computer
2
6-pin Mini DIN (or 5-pin DIN)
3
To keyboard cable
Note: The keyboard interface cable is a shielded cable. Use of a shielded
cable is required to maintain FCC and CISPR22 emissions
compliance.
compliance.
Insert the keyboard connector (attached to the keyboard) into the interface cable. (Align
the arrows, if applicable.) Push the interface cable end onto the keyboard cable end
firmly until it clicks in place and is secure.
the arrows, if applicable.) Push the interface cable end onto the keyboard cable end
firmly until it clicks in place and is secure.
Figure 2 The Cherry Keyboard Connected to the Interface Cable
Connect Keyboard to Computer
Locate the computer's keyboard connector. It may have a "Keyboard" label.
Insert the Interface cable into the computer's keyboard connector, aligning the groove on
top of the interface cable with the notch at the top of the keyed connector. Once the pins
are firmly seated, tighten (turning clockwise) the connector into place.
top of the interface cable with the notch at the top of the keyed connector. Once the pins
are firmly seated, tighten (turning clockwise) the connector into place.