Canon n1000 Installationsanweisungen

13 Perform the Printer Network Information Settings

Important

When the printer is used on a network with TCP/IP protocol, you must 
perform the network information settings such as the IP address, subnet 
mask, and so on.

z In order to perform the network settings, a network interface board must be 

installed in the printer. The optional Network Interface Board NB-11FB must be 
installed in the standard model of this printer before the printer can be connected to 
a network. (Æ P.2-7)

The methods described below can be used to perform the network settings. 
Use the method that is appropriate for the computer and network in use.

„

„

„

„

Use the operation panel buttons on the printer to perform the network 
information settings with the Setup Menu.

„

„

„

„

Use utility software to perform the TCP/IP, NetBIOS, or NetWare

®

 network 

information settings for the printer network interface board. This utility 
software is on the provided software CD-ROM.

First, check the MAC address with the Ext. I/F print from the printer, select 
and execute the Install NetSpot item from the Setup Menu of the software 
CD-ROM, then after its installation use NetSpot to perform the settings. (

Æ 

Network Guide)

„

„

„

„

On the DOS command line, or from the console screen, execute the arp 
command to perform the settings. First, check the MAC address with the 
Ext. I/F print from the printer, then set the IP address and the MAC address. 
(

Æ 

Network Guide)

00_J80xSG_Eng.book  Page 65  Saturday, April 13, 2002  11:28 AM