Jura capresso elegance grande plus Betriebsanweisung

• 12-cup capacity.

• 

Glass carafe with ergonomically 
designed safety grip handle that 
makes it safer and easier to lift a 
full carafe.

• Drip-less pouring spout.
• Drip-stop that allows you to serve a

cup while brewing.

•  Removable filter holder.
•  Water level indicator.
• Coated warming plate.
• Cord storage.
• Measuring scoop.

• Digital programmable clock/timer 

with AM/PM indicator.

• Two hour safety shut-off.
• Aroma setting (second brewing 

cycle) for small quantity brewing
(2-5 cups).

• Four indicator lights display the 

status of the coffee maker.

•  GoldTone filter. 
• Water charcoal filter. 
• Stainless steel vacuum thermal

bullet. 

When you plug in the Elegance
Grande Plus the display will flash 
“AM 12:00” and all indicator lights 
will be off.

To set the current time:
Turn and hold the program knob 
(see Fig. 2, Q) to the left (hours) to set the
hours. While you are doing this, watch
the AM change to PM. Then turn and
hold the program knob to the right
(minutes) and set the minutes.
To set the programmed time:
a. Push the program button

(see Fig. 2, R). The program light
(see Fig. 2,N) will go on and the
display will show “AM 12:00.”

b. Turn and hold the program knob 

to the left (hours) to set the hours. 
While you are doing this, watch 
the AM change to PM. Then turn 
and hold the program knob to the 
right (minutes) and set the minutes.
Within four seconds, the display 
will revert to the current time and 
the program light will turn off.

c. To change the programmed time, 

push the program button (see 
Fig. 2,R). It will show the pro-
grammed time. Then set the time as 
described above in step b.

d. To check the programmed time, 

push the program button (Fig. 2, R). 
The display will show the time you 
have  programmed to brew coffee. 
The display will switch back to the 
current time by itself after a few 
seconds.

Attention: Flashing LCD Display
If you unplug the coffee maker for
more than 15 seconds or if you have
a power failure, you will lose the cur-
rent time and program settings. The
display will flash “AM 12:00” indicat-
ing that you have to reset the current
and programmed time.

Coffee makers produce very hot
water. If you follow the sequence as
described below you will avoid 
possible accidents which might cause
severe injuries and burns.
1. Remove the glass carafe from the 

machine and then fill it with cold 
fresh water.

2. Open water container lid (Fig.1,D) 

and pour water into the water 
container (Fig.1,F).

3.  Make sure that the filter holder sits 

in the machine with the overflow 
hole pointing to the front (Fig.1, E1) 
and make sure you press the filter 
holder handle down properly.