Grindmaster PIC-2 Betriebsanweisung
Daily Cleaning
Empty drip pan as needed and wash daily in a dish detergent.
Rinse out the whipper chambers by placing the rinse switch (located to the right of the
dispensing valves when the door is open) in the ON position (“HOT RINSE” position for
CAP1 models). Dispense one to two cupfuls until the water is clear. Short bursts of
dispensing may also help clean the chambers. When complete, return the rinse switch
to the OFF position.
Remove the hoppers and refill with product.
Weekly Cleaning
Cleaning the Chambers – Disassembly
Cleaning the Chambers – Reassembly
Open the door and remove the mixing
funnel shroud by pulling forward while
funnel shroud by pulling forward while
turning one quarter turn to the right. Lift off
and remove.
and remove.
Replace the whipper blade by
lining up the flat inside the blade
lining up the flat inside the blade
with the flat side of the motor shaft.
Push blade firmly into place.
Push blade firmly into place.
Remove the mixing funnel by lifting
the neck of the funnel out of the
whipper chamber, then tilt to the left.
the neck of the funnel out of the
whipper chamber, then tilt to the left.
With one hand on the water inlet fitting on
the back panel, pull the funnel out of the
white ring.
the back panel, pull the funnel out of the
white ring.
Replace whipper chamber by
positioning the medium-sized open-
positioning the medium-sized open-
ing up and tilting 1/8 turn to the right.
Put whipper chamber over whipper
blade and turn to the left until
it locks into place.
Put whipper chamber over whipper
blade and turn to the left until
it locks into place.
Remove the whipper chamber by
rotating it 1/8 turn to the right, then
rotating it 1/8 turn to the right, then
pull to remove.
Replace the mixing funnel by posi-
tioning the large opening up and tilt
it slightly to the left. Insert the water
tioning the large opening up and tilt
it slightly to the left. Insert the water
inlet pipe into the water inlet fitting on the
back panel then rotate the funnel to the
right until the neck of the funnel seats
inside the whipper chamber opening.
back panel then rotate the funnel to the
right until the neck of the funnel seats
inside the whipper chamber opening.
Remove the whipper blade by
grasping the whipper blade with two
fingers and firmly pulling to remove.
grasping the whipper blade with two
fingers and firmly pulling to remove.
Replace the shroud by placing it on
the mixing funnel with the opening
to the right. Turn the shroud to the
the mixing funnel with the opening
to the right. Turn the shroud to the
left until the opening in the shroud rests
inside the opening in the back panel.
inside the opening in the back panel.
PARTS IN CONTACT WITH FOOD MUST BE WASHED,
RINSED, SANITIZED, AND AIR DRIED.
RINSED, SANITIZED, AND AIR DRIED.
1.
3.
2.
1.
2.
3.
4.
5.
1.
2.
3.
4.
Flats
Powdered Beverage Dispensers
Operator Manual
NOTE: Install instructions on back page.
English