Muratec F-520 Installationsanweisungen

16

Installation Manual

If a DHCP (Dynamic Host Configuration Protocol) server is installed on 

your network, an IP address is automatically assigned after you connect the 

machine to the network.
 

  To see the assigned IP address for your machine, print the “Network set-

ting list”.  by pressing [Setting]  [List]  [Network Settings]  [Yes] on 

the control panel. 

 

  Go to “Verifying the IP settings” on page 19 and begin with step 2.

NOTE: Once the DHCP server has assigned the IP address to your machine, that 

IP address MUST be reserved within the specific DHCP scope. Failure to 

do so could result in failed operation when the IP address lease expires.

You should turn off the DHCP server setting. Then enter the IP address manu-

ally to install your machine on your network.
 

  Press [Setting] on the control panel, then [Management].

 

 

  Press [Network Settings].