Ricoh 2035e Benutzerhandbuch

4. Windows Configuration

Configuring TCP/IP

This describes how to configure Win-
dows for TCP/IP and IPP.

Configuring a Windows
95/98/Me Computer

Follow the procedure below to con-
figure a Windows 95/98/Me compu-
ter to use TCP/IP.

AAAA

Open [Control Panel], and then
double-click the Network icon.
Make sure [TCP/IP] is listed in the
[The following network components
are installed]

box on the [Configura-

tion]

tab.

Note

❒ Under Windows Me, if you

want to use IEEE 1394 (IP over
1394) interface, make sure TCP/
IP is bound to the IEEE 1394
adaptor being used. The follow-
ing message appears:

TCP/ IP -> (IEEE 1394
adaptor in use)

❒ If TCP/IP is not installed, click

[Add]

on the [Configuration] tab to

install it. For more information
about installing TCP/IP, see
Windows 95/98/Me Help.

BBBB

Configure TCP/IP using the ap-
propriate IP address, subnet
mask, and other settings.
Check with the network adminis-
trator that the settings are correct.

Configuring a Windows 2000
Computer

Follow the procedure below to con-
figure a Windows 2000 computer to
use TCP/IP.

AAAA

On the [Start] menu, point to [Set-
tings]

, and then click [Network and

Dial-up Connections]

BBBB

Double-click [Local Area Connec-
tion]

. On the [General] tab, click

[Properties]

CCCC

Make sure [Internet Protocol
(TCP/IP)]

is selected in the [Compo-

nents checked are used by this connec-
tion]

box on the [General] tab.

Note

❒ Select TCP/IP if it is not already

selected.

❒ If TCP/IP is not installed, click

[Install]

on the [General] tab to in-

stall it. For more information
about installing TCP/IP, see
Windows 2000 Help.

DDDD

Configure TCP/IP using the ap-
propriate IP address, subnet
mask, and other settings.
Check with the network adminis-
trator that the settings are correct.