Ricoh AP610N Netzwerkanleitungen

Monitoring and Configuring the Printer

90

Use the "ifconfig" command to con-
figure TCP/IP (IP address, subnet
mask, broadcast address, default
gateway address) for the printer.

❖

❖

❖

❖ View settings

❖

❖

❖

❖ Configuration

• If you did not enter an interface

name, it is automatically set to
the Ethernet interface.

• ip1394 can be specified only

when the IEEE 1394 interface is
installed.

• wlan can be specified only

when the IEEE 802.11b interface
is installed.

❖

❖

❖

❖ Netmask configuration

❖

❖

❖

❖ Broadcast address configuration

❖

❖

❖

❖ Changing the Interface

• You can specify either the Eth-

ernet interface or IEEE 802.11b
interface when using the op-
tional IEEE 802.11b interface
unit.
You cannot specify the IEEE
1394 interface.

The following explains how to con-
figure an IP address 192.168.15.16
on Ethernet interface.

msh> ifconfig ether 192.
168.15.16
The following explains how to con-
figure a subnet mask 255.255.255.0
on Ethernet interface.

❒ To get the above addresses, contact

your network administrator.

❒  Use the default configuration if you

cannot obtain setting addresses.

❒ The IP address, subnet mask and

broadcast address are the same as
that for the ethernet interface and
IEEE 802.11b interface.

❒ When installing the optional 1394

Interface board, set the IP address
and subnet mask so that it does not
overlap with the ethernet interface
or the IEEE 1394 interface.

❒ TCP/IP configuration is the same

for both Ethernet and IEEE 802.11b
interface. If interfaces are changed,
the new interface inherits the con-
figuration.

❒ Use "0x" as the initial two letters of

a hexadecimal address.

ether

Ethernet Interface

ip1394

IEEE 1394 Interface

wlan

IEEE 802.11b Interface