Ricoh AP610N Zusätzliches Handbuch

Paper and Other Media

12

Avoid using the following paper as they are not supported by this printer.

• Paper meant for an ink-jet printer

• Bent, folded, or creased paper

• Curled or twisted paper

• Torn paper

• Wrinkled paper

• Damp paper

• Paper that is dry enough to emit static electricity

Additional cautions

•

Print speed for OHP transparencies is slower than for plain pa-
per.

•

Due to switching modes, the machine will be on standby for 
thirty or forty seconds after the job was received.

Printer setup

Press [Paper Input] menu, [Paper Type], and then press [Thick Paper] 
on the control panel.

❒ The paper type selected using the printer driver overrides that 

selected using the control panel.

Printer driver setup

Click [Thick] in the [Type:] list.

Enabled paper feeding tray Any input tray can be used.

❒ Make sure paper is not stacked higher than the upper limit 

mark (T) inside the tray. Make sure paper is not stacked higher 
than the paper guides inside the bypass tray.

Both-sided printing

Not possible

Additional cautions

•

Check the print side is facing up.

•

Check there is no air in the envelopes before loading.

•

For better print quality, we recommend the right, left, top, and 
bottom print margins to be at least 20 mm (0.8”) each.

•

Load only one size and type of envelope at a time.

•

Before loading envelopes, flatten their leading edges (the edge 
going into the printer) by running a pencil or ruler across them.

•

Some kinds of envelope might cause misfeeds, wrinkles or 
print poorly.

•

Print quality on envelopes may be uneven if parts of an enve-
lope have differing thicknesses. Print one or two envelopes to 
check print quality.