Ricoh gx3000n Anleitung Für Quick Setup
2
E
Reattach the network interface
board cover to the printer, and
then fasten it using the screw.
board cover to the printer, and
then fasten it using the screw.
Note
❒ Be sure to push the network in-
terface board fully into the
printer.
printer.
❒ If the network interface board is
not installed properly, repeat
the entire installation proce-
dure.
the entire installation proce-
dure.
❒ To check whether the network
interface board has been in-
stalled correctly, print the con-
figuration page. If the network
interface board has been in-
stalled correctly, its device
name appears under “Connec-
tion Equipment”.
stalled correctly, print the con-
figuration page. If the network
interface board has been in-
stalled correctly, its device
name appears under “Connec-
tion Equipment”.
❒ If you cannot install it properly
even after attempting reinstalla-
tion, contact your sales or serv-
ice representative.
tion, contact your sales or serv-
ice representative.
Reference
For details about specifying the
network settings and printing
the configuration page, see
Quick Installation Guide.
For details about specifying the
network settings and printing
the configuration page, see
Quick Installation Guide.
Dispose of the removed compo-
nent as general plastic waste or
hand it in for collection.
nent as general plastic waste or
hand it in for collection.
Copyright © 2005
Printed in Japan
GB GB EN USA J508-6617
TosP1-GB_NIB_F_FM_forPaper.book Page 2 Wednesday, October 26, 2005 4:30 PM