Frigidaire gleb30s9fsa Benutzeranleitung
2
Setting the Clock
1
3
0
START
Clock
for 7 seconds
INSTRUCTIONS
PRESS
DISPLAY
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
START
or
Clear
/Off
The
Clock
pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash along with "PF" (power failure, See Figure 1).
range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash along with "PF" (power failure, See Figure 1).
When PF appears in the display and 12:00 is flashing, press
Clear
/Off
.
No sound will be heard,
but after 10 seconds a beep will sound and PF will disappear.
To set the clock (example below for 1:30)
1.
Press
Clock
. "CLO" will appear in the display (Figure 2).
2.
Press
1
3
0
pads to set the time of day to 1:30 (Figure
3). "CLO" will stay in the display. Press
START
. "CLO" will
disappear and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display
1.
Press and hold
Clock
for 7 seconds (Figure 3). After 7 seconds,
"12Hr" (Figure 5) or "24Hr" (Figure 6) will appear in the display
and the control will beep once.
and the control will beep once.
2.
Press
Clean
to switch between the 12 and 24 hour time of day
display. The display will show either "12Hr" (Figure 5) or "24Hr"
(Figure 6).
(Figure 6).
3.
Press
START
to accept the change or press
Clear
/Off
to reject the
change.
4.
Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen,
the clock will now display time from 0:00 through 23:59 hours.
Please note that if the 24 hour time of day mode was chosen,
the clock will now display time from 0:00 through 23:59 hours.
Clean
Clock