Frigidaire fefs68cjtc Installationsanweisungen

 If the information in this manual is not

followed exactly, a fire or electrical shock may result

causing property damage, personal injury or death.

1. Read all instructions contained in these installation

instructions before installing range.

2. Remove all packing material from the oven

compartments before connecting the gas and electrical

supply to the range.

3. Observe all governing codes and ordinances.

4. Be sure to leave these instructions with the consumer.

Keep these instructions with your owner's guide for  future

reference.

• As when using any appliance generating heat, there

are certain safety precautions you should follow. You

will find them in the Owner's Guide, read it carefully.

• Be sure your range is installed and grounded properly

by a qualified installer or service technician.

• Make sure the wall coverings around the range can

withstand the heat generated by the range.

• To eliminate the need to reach over the surface burners,

cabinet storage space above the burners should be

avoided.

•

Adjustable wrench or channel lock pliers 

• 5/16" Nutdriver or Flat Head Screwdriver 
• Electric Drill & 1/8" Diameter Drill Bit (Masonry Drill Bit

if installing in concrete)

• 1/4" & 3/8" Socket driver or Nutdriver 

• Power Supply Cord or 

• Copper Electrical Wiring & Metal Conduit (for hard

wiring)

To reduce the risk of tipping of the range, the range must

be secured to the floor by properly installed anti-tip bracket

and screws packed with the range. Failure to install the

anti-tip bracket will allow the range to tip over if excessive

weight is placed on an open door or if a child climbs upon

it. Serious injury might result from spilled hot liquids or

from the range itself.
If range is ever moved to a different location, the anti-tip

brackets must also be moved and installed with the range.
Instructions are provided for installation in wood or cement

fastened to either the floor or wall.  When installed to the

wall, make sure that screws completely penetrate dry wall

and are secured in wood or metal.  When fastening to the

floor or wall, be sure that screws do not penetrate electrical

wiring or plumbing.
A. Locate the Bracket Using the Template - (Bracket may

be located on either the left or right side of the range.

Use the information below to locate the bracket if

template is not available).  Mark the floor or wall where

left or right side of the range will be located.  If rear of

range is against the wall or no further than 1-1/4" from

wall when installed, you may use the wall or floor

mount method. If molding is installed and does not

allow the bracket to fit flush against the wall, remove

molding or mount bracket to the floor. For wall mount,

locate the bracket by placing the back edge of the

template against the rear wall and the side edge of

template on the mark made referencing the side of the

range. Place bracket on top of template and mark

location of the screw holes in wall.  If rear of range is

further than 1-1/4" from the wall when installed, attach

bracket to the floor.  For floor mount, locate the

bracket by placing back edge of the template where

the rear of the range will be located.  Mark the location

of the screw holes, shown in template.

· ALL RANGES

CAN TIP.

· INJURY TO

PERSONS

COULD

RESULT.

· INSTALL

ANTI-TIP

DEVICE

PACKED WITH

RANGE.

· SEE

INSTALLATION

INSTRUCTIONS.