Frigidaire fgef304dk Betriebsanweisung

Seite von 40
18
SETTING OVEN CONTROLS
NOTE
The  surface  elements  cannot  be  activated  when  the 
Lockout feature is active (see the section: The electronic 
surface element control (ESEC)).
SETTING LOCKOUT FEATURE
The 
 pad controls the Lockout feature. The Lockout 
feature  automatically  locks  the  oven  doors,  the  control 
panel  and  the  cooktop.  It  does  not  disable  the  Minute 
Timer or the interior oven lights.
To activate the Lockout feature
1.  Press and hold 
 for 3 seconds.
2.  After  3  seconds  “Loc”  and  “Control”  will  appear,  a 
beep will sound, “UPPER”, “LOWER” and “DOOR” will 
fl ash in the display. Once the oven door is locked the 
DOOR” will stop fl ashing and remain on along with 
the “Loc”, “Control” and the   icon will appear.
To reactivate normal operation:
1.  Press and hold 
 for 3 seconds. A beep will sound. 
The “UPPER”, “LOWER” and “DOOR” will fl ash in the 
display until the oven door has completely unlocked and 
the   icon will disappear.
2.  The unit is again fully operational.
SETTING MINUTE TIMER
The TIMER ON.OFF pad controls the Minute Timer feature. 
The Minute Timer serves as an extra timer in the kitchen 
that will beep when the set time has run out. It does not 
start  or  stop  cooking.  The  Minute  Timer  feature  can  be 
used during any of the other oven control functions. Refer 
to “Minimum and Maximum Control Pad Settings” for time 
amount settings.
To set the Minute Timer (example for 5 minutes)
1.  Press  TIMER  ON.OFF.  --  --”  will  appear  in  the 
display.
2.  Use the number pads to set the desired time in the 
display; press 5.
3.  Press START. The time will begin to count down with 
5:00” in the display.
Note: If START is not pressed the timer will return to the 
time of day after 25 seconds.
4.  When  the  set  time  has  run  out,  “End”  will  show  in 
the display. The clock will sound with 3 beeps every 5 
seconds until TIMER ON.OFF is pressed.
To cancel the Minute Timer before the set time has 
run out
1.  Press TIMER ON.OFF. The display will return to the time 
of day.
SETTING ADD 1 MINUTE FEATURE
The ADD 1 MINUTE pad is used to set the Add 1 Minute 
feature.  When  the  ADD  1  MINUTE  pad  is  pressed,  1 
minute is added to the Minute Timer feature if this feature 
is already active. If the Minute Timer feature is not active 
and the ADD 1 MINUTE pad is pressed, the Minute Timer 
feature will become active and will begin counting down 
from 1 minute.
SETTING SILENT CONTROL OPERATION
The  DELAY  START  and  SELF  CLEAN  pads  control  the 
Silent Control operation feature. The Silent Control operation 
feature  allows  the  oven  control  to  be  operated  without 
sounds or beeps whenever necessary. If desired the control 
can be programmed for silent operation and later returned 
to operating with all the normal sounds and beeps.
To change control from normal sound operation to 
silent control operation
1.  To tell if your range is set for normal or silent operation 
press and hold DELAY START. “-- --” will appear and 
DELAY” will fl ash in the display. After 6 seconds “bEEP 
On” or “bEEP OFF” will appear in the display.
2.  Press SELF CLEAN to switch between normal sound 
operation and silent operation mode. The display will 
show either “bEEP On” or “bEEP OFF”.
Note: If “bEEP On” appears, the control will operate with 
normal sounds and beeps.  If “bEEP OFF” appears, 
the control is in the silent operation mode.
3.  Press START to accept the change or press CANCEL 
to reject the change.
Note: The control will always beep at the end of a minute 
timer and will beep when a set temperature has been reached, 
even if the control is set to silent operation.