Frigidaire fgf354bgwc Betriebsanweisung

17

 Use caution when

replacing the burner cap so the electrode

is not damaged. This may cause a delayed

ignition or prevent the burner from

igniting.

 Any additions, changes or

conversions required in order for this

appliance to satisfactorily meet the

application needs must be made by an

authorized Frigidaire Distributor or

Qualified Agency.

Note: The burner cap assembly refers to

all parts of the sealed burner unit (burner

cap, burner pan (some models), trim ring

(some models), locating tab, burner base

and electrode).

Unlike the standard gas range, THIS

COOKTOP IS NOT REMOVABLE. Do not

attempt to remove or lift the cooktop.

The cooktop is designed to make cleaning easier. Because the four burners are

sealed, cleanups are easy when spillovers are cleaned up immediately.

To clean, wipe with a clean, damp cloth and wipe dry.

The contoured well areas, burner cap assembly, trim ring (some models), burner pan

(some models) and burner base should be routinely cleaned. Keeping the burner

ports clean will prevent improper ignition and an uneven flame. See instructions

below.

The contoured well is a recessed area located around each burner unit. If a spill occurs

in one of the four well areas, blot up spill with an absorbent cloth. Rinse with a clean,

damp cloth and wipe dry.

The burner cap assembly parts differ per model. Your assembly will consist of one

of the following combinations: burner cap and trim ring; burner cap and burner pan;

or burner cap, trim ring and burner pan. Remove in the following order: (1st) burner

cap, (2nd) trim ring and (3rd) burner pan.  Do not operate the burners without

Use a soap-filled scouring pad or a mild abrasive cleanser to clean burner caps, trim

rings and burner pans.

The ports (or slots) around the burner base must be routinely cleaned. Use a small-

gauge wire or needle to clean small slots or holes.Use care to prevent damage to the

electrode. If a cleaning cloth should catch the electrode, it could break or damage

the electrode. If the electrode is damaged or broken, the surface burner will not light.

For proper flow of gas and ignition of the burner—DO NOT ALLOW SPILLS, FOOD,

CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS OPENING. Gas

must flow freely through the small hole in the brass orifice for the burners to light

properly. If the orifice gas opening becomes soiled or clogged, use a small-gauge

wire or needle to clean. ALWAYS keep the burner cap assembly in place whenever

a surface burner is in use.

Make sure the burner cap assembly is thoroughly dry before placing back on the

burner.

1. Lower burner pan (some models) into place around the burner base.

2. Replace trim ring (some models).

3. Find the locating tabs on the burner cap and place in the locating slots in the

burner base. Make sure each burner cap is properly aligned and level.

4. Turn the burner on to determine if it will light. If the burner does not light after

cleaning, contact an authorized servicer. Do not service the sealed burner

yourself.