Frigidaire fgf379wxbca Benutzeranleitung

To Remove and Replace Oven Bottom

To Remove Oven Bottom:

1. Remove the oven racks.

2. Remove the two hold-down screws (Figure 1) at the rear of the oven

bottom panel. If the screws are too tight to remove by hand, use a

screwdriver.

3. To lift out the bottom panel, place fingers in the slots in the bottom. Lift

the rear of the panel up and back until it is clear of the lip at the front of

the panel (Figure 2).

4. Lift the bottom up and out.

To Replace the Oven Bottom:

1. Place the oven bottom in the oven with the back raised about 6" or until

you can insert the front of the oven bottom under the hold-down lip at the

front of the panel.

2. Push the back of the oven bottom down fully into place on the metal

flanges and insert the hold-down screws.

Figure 1

Figure 2

General Cleaning

Changing Cooktop

and/or Oven Lights

(if equipped)

Be sure the range is unplugged and all parts are COOL before

replacing the surface or oven lights. Wear a leather-faced glove for protection

against possible broken glass.

To Change the Cooktop Light (some models)

1. Turn power off at the main source or unplug the range.

2. Remove Phillips® Head screws (2) that secure the light cover and then lift

the light cover off.

3. Remove bulb by rolling back and up. Install the new bulb by sliding down

and rolling forward into place.

4. Re-install light cover and secure with Phillips® Head screws (2).

To Change the Oven Light (some Self Cleaning Models)

On some models, the oven light automatically turns on when the door is

opened. Some models have a switch located on the control panel to turn on

the light. The oven light is located at the rear of the oven and is covered with

a glass shield held by a wire holder. The glass shield must be in place whenever

the oven is in use.

To replace the oven light:

1. Turn electrical power off at the main source or unplug the range.

2. Press wire holder to one side to release the glass shield.

3. Replace bulb with a new 40 watt appliance bulb.

4. Replace glass shield over bulb and snap wire holder into place.

5. Turn power back on again at the main source (or plug the range back in).

6. The clock(if equipped) will then need to be reset. To reset, see Setting the

Clock and Minute Timer in this Owner's Guide.