Frigidaire FPEF4085KF Betriebsanweisung

Seite von 36
30
Figure 3
Figure 4
Oven door
Around
Hinge
care & cleaning
caution
The door is heavy. For safe, temporary storage, lay the 
door flat with the inside of the door facing down.
Removing and replacing the main oven
door (If equipped with hinge style A)
To Remove Oven Door:
1.  Open oven door completely (horizontal with floor - 
See Figure 1).
2.  Pull the door hinge locks on both left and right 
door hinges down from the oven frame completely 
towards the oven door (See Figure 2). A tool such as 
a small flat-blade screwdriver may be required.
3.  Firmly grasp both sides of oven door along the door 
sides (Do not use the oven door handle - See Figure 3).
4.  Close the door to the broil stop position (the oven door 
will stop into this position just before fully closing).
5.  With the oven door in the broil stop position, lift the 
oven door hinge arms over the roller pins located on 
each side of the oven frame (See Figure 4).
To Replace Oven Door:
1.  Firmly grasp both sides of oven door along the door 
sides (Do not use the oven door handle - See Figure 3).
2.  Holding the oven door at the same angle as the 
removal position, seat the hook of the hinge arm over 
the roller pins located on each side of the oven door 
frame (See Figure 4). The hook of the hinge arms 
must be fully seated onto the roller pins.
3.  Fully open the oven door (horizontal with floor - See 
Figure 1).
4.  Push the door hinge locks up towards and into the 
oven frame on both left and right oven door hinges 
(See Figure 2) to the locked position.
5.  Close the oven door.
Door Hinge locations
with oven door fully open
Figure 1
Figure 2
cooktop which
can burn and 
cause Special
caution for 
aluminum Foil 
and aluminum 
cooking utensils
cleaning recommendations for the 
ceramic glass cooktop (continued)
Plastic or foods with a high sugar content:
These types of soils need be removed immediately if spilled 
or  melted  onto  the  ceramic  cooktop  surface.  Permanent 
damage (such as pitting of the cooktop surface) may occur 
if  not  removed  immediately.  After  turning  the  surface 
elements OFF, use a razor blade scraper or a metal spatula 
with a mitt and scrape the soil from the hot surface (as 
illustrated). Allow the cooktop to cool, and use the same 
method for heavy or burned on soils.
do not use the following on the ceramic glass 
cooktop:
•  Do not use abrasive cleaners and scouring pads,
such as metal and some nylon pads. They may
scratch the cooktop, making it more difficult to
clean.
•  Do not use harsh cleaners, such as chlorine
bleach, ammonia or oven cleaners, as they may
etch or discolor the cooktop.
•  Do not use dirty
sponges, cloths
or paper towels,
as they can leave
soil or lint on the 
aluminum foil
  Use of aluminum foil will damage the cooktop. Do not 
use under any circumstances.
aluminum utensils
  Since the melting point of aluminum is much lower 
than that of other metals, care must be taken when 
aluminum pots or pans are used. Pans that boil dry 
may permanently damage cooktop by breaking, fusing 
to, or marking it.
care and cleaning of stainless steel
Some models are equipped with stainless steel exterior 
parts. Special care and cleaning are required for 
maintaining the appearance of stainless parts. Refer 
to the general care & cleaning table for detailed 
cleaning instructions.