Bertazzoni X365GGVX Installationsanweisungen

Seite von 26
 
3
WARNING: Do not use aerosol sprays in the vicinity of this appliance while it is in operation 
Requirements 
Room ventilation – Location and venting. 
ATTENTION: An exhaust fan may be used with the appliance; in each case it shall be installed in 
conformity with the appropriate national and local standards. 
ATTENTION: Exhaust hood operation may affect other vented appliances; in each case it shall be 
installed in conformity with the appropriate national and local standards. 
 
INSTALLATION MANUAL 
ANTI-TIP STABILlTY DEVICE INSTALLATION INSTRUCTIONS 
1. The anti-tip bracket have to be  installed to the rear wall as shown. The height for the bracket location from 
the floor has to be determined after the range legs have been adjusted to the proper installation height - as 
shown in the installation instructions – and after  the range has been leveled.  
2. Measure from the floor to the bottom of the anti-tip bracket location on the back of the range. 
3. Position the two anti-tip brackets on the wall at the measured dimension plus 1/8" (0.32 cm). The brackets 
have to be placed at 2”5/16 (6,0 cm) from the side of the range. The distance between the two bracket is  
31”1/4 (79,3 cm) clearance. Secure with suitable inserts. 
4. Slide the range against the wall until the brackets are fully inserted into the holes on the backside of the 
range.. 
 
Height adjustable legs: 
1. Legs are packed in the  top box. 
2. Legs should be installed with the appliance being near the location of final installation, they are not secure 
for long transport. After unpacking the range, raise it about a foot to insert the legs in their bases assembled 
on the lower part of the cooker and lower the range gently to keep any undue strain from legs and mounting 
hardware. It is recommended to use a pallet or lift jack instead of tilting the unit.